Manual No. 775029
1-1
Chapter 1
First-Time Configuration
Welcome!
Welcome to RAID EzAssist™, Mylex Corporation’s user friendly
configuration and maintenance utility for RAID controllers. This chapter
will help you get started step by step doing your first Mylex RAID
Controller configuration.
Before you are ready to configure a controller, be sure that you have already
done the following according to the instructions in your controller’s quick
installation or hardware installation guide:
• Installed your Mylex controller(s) in the target system
• Connected appropriate cables between your controller(s) and the set of
disk drives which you intend to use with each controller
• Set unique SCSI IDs for each drive on a particular SCSI bus (i.e.
attached to each Mylex RAID controller)
• Terminated each SCSI bus appropriately
If you have installed only one Mylex RAID Controller in your target system,
see the section called “How Do I Configure a Mylex Controller for the First
Time?” on page 1-2.
If you have installed two or more Mylex RAID Controllers in your target
system, see the section called “How Do I Configure Multiple Mylex
Controllers?” on page 1-36.
