How Do I Configure Multiple Mylex Controllers?
1-38
RAID EzAssist User’s Manual
“Would you like to configure a RAID drive now?”
The answer depends in part on whether you want to change any of the
default parameters and settings for this Mylex RAID Controller. If you are a
new or inexperienced user, the default settings will probably suit your needs
just fine.
If you are an advanced user, now’s the time to change any controller
parameters that you wish-- before a RAID configuration is set on the
controller!
Also, if you answer YES to the question above and multiple controllers are
installed, RAID EzAssist will automatically select the FIRST controller that
has unconfigured drives (usually Controller 0). If you want to configure a
controller other than this, you’ll have to answer NO.
☞
If you want to adjust controller parameters, or if you want to
configure a controller other than the default, use the arrow key
to select No, then press Enter.
Please see Chapter 3 for information on changing Global, SCSI, and Startup
parameters. Return here when you’re done to continue first-time RAID
configuration.
☛
Note
After changing controller parameters, select
Configure a RAID Drive from the main menu to
proceed.
☞
If you want to begin configuring your first RAID drive without
changing controller options, or if you want to configure the
default controller, press Enter with Yes selected.
If you answered Yes, please continue from the “Choose a Configuration
Method” step in “How Do I Configure a Mylex Controller for the First
Time?”
If you answered No, you should now select a controller (Figure 1-31).
