First-Time Configuration
Manual No. 775029
1-33
■
Apply the Configuration to the Controller.
In order for the disk arrays and logical drives you set up to become a valid,
registered configuration, you must Apply the configuration to the controller.
☞
To apply the configuration, press Tab if necessary to switch
focus to the buttons, use the arrow key to select Apply, then
press Enter,
OR
☞
To cancel the configuration, press Tab if necessary to switch
focus to the buttons, use the arrow key to select Cancel, then
press Enter.
When you apply the new configuration, RAID EzAssist writes configuration
information to the Mylex controller. This takes a few moments, so a message
is displayed (Figure 1-26).
Figure 1-26. Writing RAID Configuration. Please Wait...
☞
Wait for the configuration information to be written to the
controller.
