How Do I Do a Custom Configuration?
2-34
RAID EzAssist User’s Manual
☞
To define additional logical drives, use the arrow key if
necessary to return to the RAID Level definition field. Repeat the
steps described in “Define Logical Drives.”
As long as you haven’t applied the configuration to the controller, you can
delete the logical drives you’ve set up and define new ones. RAID EzAssist
lets you:
• Delete the most recent logical drive you’ve added, OR
• Delete all the logical drives you’ve added.
☞
To delete the most recently-added logical drive, press Tab if
necessary to switch focus to the buttons, use the arrow key to
select Delete Last, then press Enter.
☞
To delete all logical drives that you added, press Tab if
necessary to switch focus to the buttons, use the arrow key to
select Clear All, then press Enter.
☞
Define new logical drives, as described in “Define Logical
Drives.”
❑
Apply the Configuration to the Controller.
In order for the disk arrays and logical drives you set up to become a valid,
registered configuration, you must Apply the configuration to the controller.
☞
To apply the configuration, press Tab if necessary to switch
focus to the buttons, use the arrow key to select Apply, then
press Enter,
OR
☞
To cancel the configuration, press Tab if necessary to switch
focus to the buttons, use the arrow key to select Cancel, then
press Enter.
When you apply the new configuration, RAID EzAssist writes configuration
information to the Mylex controller. This takes a few moments, so a message
is displayed (Figure 2-27).
