MUTOH DT-Series, Operation Instructions Manual

Page: 92 / 96

Mutoh’s DT-Series Printers – Operation Instructions
92
AP-75171, Rev. 1.1, 25/06/04
Setup item
Parameter Description
Ink status Displays information on the
ink cartridge installed in the
ink cartridge slot.
Origin setting
Makes setting on the print
head position at the start of
printing.
Performs test printing.
SetupPrint Performs setup printing.
NozzleCheck Performs nozzle check
printing.
AdjustPrint
(UniDir)
Performs accuracy
adjustment printing in one
direction.
AdjustPrint
(BiDir)
Performs accuracy
adjustment printing in two
directions.
Pallet printing Performs pallet printing.
Test print
Maintenance Performs maintenance status
printing.
Makes various media
settings.
Makes settings for media type
used for test printing.
ThinOut
50% to 100% Adjusts the ink discharge
amount during printing
depending on the time the
media requires for printing.
InkDryTime 0 to 30 sec . to
270 sec. to 60
min.
Makes the setting for the
waiting time for ink drying
from the end of printing to
cutting the roll media.
HeadHeight
Low / Middle /
High
Makes the setting for the
distance between the head
surface and the media,
depending on the thickness of
the media.
Vacuum Low / Medium /
High
Makes the setting for the
suction of the media to the
print platform.
Thick 50µm to 100µm
to 1500µm
Makes the setting on the
width of the media to be used.
Heater
Set the temperature of the
Heater.
Drier Set the temperature of the
Drier.
HStatus Check the temperature of
Heater and Drier.
User1
Dist.Adj
Print1 / change /
Print2 Perform various settings for
media feed compensation
User2 Same items as User1
User3 Same items as User1
User4 Same items as User1
User5 Same items as User1
User6 Same items as User1
User7 Same items as User1
Media
User8
Same items as User1
Cut size
Auto / Length /
Width
Sets the method of the media
size detection when loading
the sheet media.
Top Feed
0mm -400mm Feeds the media when
printing starts. Set when
printing the roll media.
Media set
Media Cut Auto / Manual /
OFF
Sets the method of the media
cutting after printing.