V 1.6
9
2. Installation
2.1 Mounting
Modules of the IMPACT67-P product lines can be mounted directly on an installation wall or on
a machine. Two mounting holes are provided for this purpose in the module.
Before mounting a module, make sure the mounting surface has no unevenness that will cause
mechanical stresses in the housing.
Two bolts with a diameter of 6 mm and two DIN 433 T1/T2 washers are required to mount each
module. The correct tightening torque is 3 Nm.
Fig. 2:
Figure: Mounting dimensions
We advise you to maintain a minimum spacing of 3 mm when mounting the
IMPACT67-P to guarantee professional installation and enhanced heat
dissipation.
Angled plugs from Murrelektronik require a minimum spacing of 50 mm.
Please refer to our accessory information on page 36.
www.comoso.com