Section 50
00-02-0329
01-09-07 -
17 -
Operational Display Messages
Several messages display during the start-up and run sequence. This tutorial shows the
screens that will display as the system starts. With the unit in shutdown state and ready to
start, press the [RESET] key. If Class A inputs are not faulted, and the unit is equipped with the
Pre/Post Lube option, the unit goes into the Pre-Lube cycle. If the unit does not have the Pre-
Lube option, it will go to the B1 Timer display.
Lube Timer 5 shows the remaining time on the cycle and the LUBE
icon shows on the display. The Pre-Lube cycle can be completed
either by the timer reaching “zero,” or the operator pressing [TIMER
0]. Pressing the [TIMER 0] key will zero the time on the active visible
timer only. All other active undisplayed timers will remain the same.
Once the Pre-Lube cycle completes, the outputs change state, and
the B1 and B2 timers start. This display shows TIMER 1 as the
remaining B1 time counts down.
If this is a TTD unit with optional Tachometer, the display alternates
between the active TIMER and RPM readings. If the TTD unit does
not have Tachometer, the active TIMER reading alternates with the
HOURS reading.
Once the B1 Timer finishes, any time remaining on the B2 timer will
show in the display and the TIMER 2 icon will be visible in the lower
right hand corner of the display.
On TTD models supplied with tachometer, once the B1 and B2
timers have expired, the unit goes to a normal Run Mode. Both the
RUN and RPM icons will be visible, and the display gives the RPM
reading. TTD units without the Tachometer display the HOURS
reading.
Any conditions such as LOW BATT or ALARM alert the operator by
having the icon show on the display. LOW BATT indicates low
voltage on the Backup battery, and may indicate it is time to replace
the battery.
At the detection of a fault, the TTD annunciator starts the shutdown
sequence. The ignition delay timer shows the time remaining on the
timer before the ignition is grounded or turned off. In addition, the
fault channel shows on the left side of the display and flashes.
If the TTD annunciator is equipped with the Pre/Post Lube option and
there is time remaining in the sequence, the POSTLUBE icon and
the TIMER 6 icon displays showing the remaining time on the timer.
To order call 1-800-548-1191 or visit www.partdeal.com - [email protected]