Muratec F-65, Operating Instructions Manual

Page: 68 / 114

2
Press
ENTER
. The
LCD
either shows:
… or indicates a command is already programmed into this key.
If
P
1 is the key you want to program, skip to step 4. (However, our examples
from here will say “
P
3” rather than “
P
1.”)
3
Select the key in which you want to program a command or change a previ-
ously stored command and then press it. Here, we select
P
3.
4
If you decide to select a different programmable one-touch key, go back to
step 3 before going on to step 5.
5
Press
ENTER
. The
LCD
now shows briefly:
then it will show either:
or
6
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number
can be up to 40 characters in length:
Important: Do not press
ENTER
.
Your display can show only 16 characters at a time. To view characters beyond
those 16, press
to scroll to the left or to scroll to the right.
Note: If you make a mistake or want to erase previously entered numbers,
press
CANCEL
to erase to the left. Or to change just one character in
the number, press to move the cursor to the left, or to move it to
the right, to that character and press
CANCEL
to erase it. Then re-
enter until the number is just as you want it.
7
Now, while you can still see the fax number on the
LCD
, press
COM
-
OPTIONS
five times. The
LCD
shows:
8
Press
ENTER
. The
LCD
shows briefly:
9
Enter an
ITU
-
T
subaddress for the box to which you want to send the docu-
ment. The
ITU
-
T
subaddress can be up to 20 characters in length and can
include any combination of numbers and the * and # symbols. Do not include
other non-numerical characters.
In this example, we enter 6*54321#.
10
Press
ENTER
. The display will show briefly:
Note: If you know that this
ITU
-
T
subaddress does not have a
ITU
-
T
pass-
word, skip to step 12.
11
Enter a appropriate
ITU
-
T
password for the box. The
ITU
-
T
password can be up
to 20 characters in length and can include any combination of numbers and
the * and # symbols (but no other non-numerical characters). In this example,
we enter 1*23456#1.
Note: If you make a mistake, press
CANCEL
to back up, then enter the cor-
rect number.
When the entry is complete, press
ENTER
.
12
If you want the transmission to begin immediately every time you press the
key, press
ENTER
again and skip to step 15.
If you want to delay the transmission, press
COM
-
OPTIONS
,
COM
-
OPTIONS
,
ENTER
.
1*23456#1_
_
Enter Password
6*54321#_
_
Enter SubAddress
5.F-Code Tx
9-555-0629_
9-555-7312_ _
P3:Fax Number
P3:No Number
P1:No Number
Beyond the basics
2.33