Multitech ProxyServer MTPSR3-200, User Manual, Page: 14 / 130

ProxyServer User Guide
MTPSR3-200 14
Adding RAM
A second SIMM connector is provided for adding RAM to the ProxyServer. Do the following.
Note: Memory should only be added when required by Multi-Tech Systems.
1. Ensure that the external power supply is disconnected from the ProxyServer.
2. Turn the ProxyServer upside down and remove the cabinet mounting screw (1) located at the
center back of the cabinet (Refer to Figure 2-3).
Cabinet Mounting Screw
(center, back)
Figure 2-3. Cabinet Mounting Screws
3. Turn the ProxyServer right side up and tilt the back down slightly and the base will slide out of the
cabinet.
4. Place the unit in a position where the LEDs are facing you.
5. Slant the new SIMM at a 45
0
angle to the back of the base and align the centering notch of the
SIMM with the center tab on the SIMM connector.
6. Gently press down on the ends of the SIMM until the two latches latch over the SIMM and the
two vertical pins enter the holes in the SIMM (Refer to Figure 2-4).
Figure 2-4. Installing a SIMM
7. Slide the base back into the cabinet with the LEDs facing toward the front and the back side
grounding tabs pressing against the side of the cabinet.
8. Turn the ProxyServer upside down and replace the cabinet mounting screw (1) located toward
the front of the cabinet.
9. Turn the ProxyServer right side up and connect the cables.