Multitech MultiModem MT5634ZPW-PCI, Owner'S Manual

Page: 39 / 94

MT5634ZPW-PCI
39
3 AT Commands, S-Registers and Result Codes
S Dial a telephone number previously stored using
the &Zn=x command (see &Zn=x command for
further information). The range of n is 0-3.
, Pause during dialing for time set in register S8.
; Return to command mode after dialing. (Place at
end of dial string.)
! Hook flash. Causes the modem to go on-hook for
one-half second, then off-hook again.
@ Wait for quiet answer. Causes modem to wait for a
ringback, then 5 seconds of silence, before
processing next part of command. If silence is not
detected, the modem returns a NO ANSWER code.
$ AT&T's "call card" tones detection.
^ Disable data calling tone transmission.
Command: DS=
n Dial Stored Telephone Number
Values:
n = 0–3
Default: none
Description: Dial a number previously stored in directory number n
by the
&Zn=x command .
Example: ATDS=3
Command: E n Echo Command Mode Characters
Values:
n = 0 or 1
Default: 1
Description: E0 Do not echo keyboard input to the terminal.
E1 Do echo keyboard input to the terminal.
Command: F n Echo Online Data Characters
Values: n = 1
Default: 1
Description: F0 Enable online data character echo. (Not supported.)
F1 Disable online data character echo (included for
backward compatibility with some software).
Command: H n Hook Control
Values:
n = 0 or 1
Default: 0
Description: H0 Go on-hook to hang up.
H1 Go off-hook to make the phone line busy.