Multitech MultiModem MT5634ZPW-PCI, Owner'S Manual

Page: 88 / 94

MT5634ZPW-PCI
88
Owner’s Manual
Australian and New Zealand Modem Warning
Notice
Australian Modem Warning Notice
Modems connected to the Australian telecommunications
network must have a valid AUSTEL permit. This modem has
been specifically configured to ensure compliance with AUSTEL
Standards. The following commands can affect compliance and
must not be set outside the acceptable range.
Modem Commands:
Command Default Permissible Range
A: - Do not use
ATB B0 Do not change
AT&G &G2 Do not change
AT&P &P1 Do not change
ATSn see table below
S-Register Default Permissible Range
S6 4 2 - 5
Call Attempts/Retries:
Applications software shall be configured so that no more than 3
attempts are made to establish a connection to a given number
(Note: if the modem can detect service tones, up to 10 attempts
can be made). There must be at least 2 seconds between call
attempts. If the call sequence is unsuccessful, there shall be a
delay of at least 30 minutes before attempting to call the number
again.