Centrifugal oil filter – Cleaning
and filter sleeve replacement
1.
Loosen screw (1) and remove.
2.
Remove clamp (3) and take off hood (2).
3.
Carefully remove rotor (5) from housing.
4.
Hold rotor assembly (5) firmly in position
with filter wrench and loosen knurled
nut (7).
5.
Take off rotor cap (8).
6.
Remove filter sleeve (9), stiffener plate (10)
and sealing ring (11).
7.
Measure thickness of oil residues on filter
sleeve.
8.
If maximum layer thickness of oil residues
exceeds 30 mm, shorten maintenance in-
terval.
9.
Take off standpipe (12) from lower rotor
section (13).
10.
Wash cover (2), rotor cap (8), stiffener
plate, (10) tube (12), lower rotor sec-
tion (13) and nozzles (14) with cold cleaner
and blow out with compressed air. Do not
use sharp-edged objects for cleaning.
11.
Check nozzles (14) for obstructions.
12.
Push standpipe (12) onto lower rotor sec-
tion (13).
13.
Insert new filter sleeve (9) with stiffener
plate (10) into rotor cap (8) with the with
the smooth paper surface of the filter
sleeve (9) facing the rotor cap (8).
14.
Check sealing ring (11), fit new one if nec-
essary. Coat sealing ring with assembly
compound and insert in groove of rotor
cap (8).
15.
Place rotor cap (8) onto standpipe (12).
16.
Hold rotor assembly (5) firmly in position
with filter wrench and tighten curled
nut (7).
17.
Lubricate bearings of rotor (5), insert in
housing (6) and check for ease of move-
ment.
18.
Check sealing ring (4), fit new one if neces-
sary. Fit sealing ring on housing (6).
19.
Fit cover (2).
20.
Tighten screw (1) by hand.
21.
Install clamp (3) and tighten with torque wrench to the specified torque.
Name
Size
Type
Lubricant
Value/Standard
Clamp
Tightening torque
6 Nm +1 Nm
22.
Tighten screw (1) to specified torque using a torque wrench.
Name
Size
Type
Lubricant
Value/Standard
Screw
Tightening torque
6 Nm +1 Nm
MS150096/03E 2015-04
| Task Description | 137
TIM-ID: 0000000958 - 007
