3-17
BIOS Setup
Serial ATA
A
Embedded SATA
A
This setting allows you to enable or disable the onchip Serial-ATA controller.
SATA Mode
This setting specifies SATA controller mode.
MMIO (default value) is high-performance SATA mode. To install Windows 2003
operating system on SATA port1 to port4 (HT1000), the system should load
SATA drivers during OS installation. Please check the HT1000 MMIO driver
diskette on the Driver CD.
IDE is legacy mode for parallel IDE compatibility and is used for older operating
system such as W indows 2000/NT and older. For Linux OS installation, if
sata_svw module version is 1.06 or later, the system can install OS under MMIO
mode. Otherwise, users are advised to use IDE mode.
Enable/Disable Int13 Support
Extended INT13 support is required to access hard-disks larger than 8.4 GB. It
allows you to do drive translations from physical (CHS) to Logical (LBA).
Summary of Contents for K9SD Master
Page 1: ...i K9SD Master MS 9185 V1 X Server Board G52 S9185X1...
Page 5: ...v WEEE Waste Electrical and Electronic Equipment Statement...
Page 6: ...vi...
Page 7: ...vii...
