MSI K9SD Master, User Manual

Page: 63 / 81

A-7
Adaptec SATAII RAID
Installing the NetWare Driver
This section contains the following procedures:
Installing the NetWare Driver in a New NetWare System
Installing or Updating Device Drivers After Installing NetWare
Installing the NetWare Driver in a New NetWare System
Note:
For information about installing drivers if you use the NetWare CD to install your
operating system, see your Novell documentation.
To install the driver in a new Novell NetWare 6.5 system:
1. Install and configure the controller and hard drives as described in Installing
the Controller .
2. Use the instructions provided in the NetWare manual to begin the installation.
3. W hen the No storage device was detected in this system. Load the appropriate
driver (HAM) prompt appears, press
Enter
, then
Esc
.
4. On the Device Type screen, select
Storage adapters
, then press
Enter
.
5. If the list contains the HostRAID SATA driver (AAR81XX.HAM), select the
driver, then press the
Delete
key to delete it.
6. Press the
Insert
key twice to
Add an unlisted driver
.
7. Insert the support disk for Novell NetW are.
8. Press
F3
to specify a path, then type a:\ (where a is the diskette drive letter),
then press
Enter
.
v Note:
The driver and support files will be copied to the system volume:
AAR81XX.HAM.
9. Verify that the driver name displays in the list of device drivers that appears in
the window (for example, AAR81XX.HAM) then select
Return to Driver
Summary,
then press
Enter
.
10. Select
Continue,
then press
Enter
.
11. Follow the instructions in the NetWare manual to complete the installation.
Installing or Updating Device Drivers After Installing NetWare
To update the driver in an existing NetW are 6.5 system see Updating the Device
Drivers . To install the driver in an existing NetWare system, see Installing the Device
Drivers .
Updating the Device Drivers
1. Reboot your system to DOS.
2. At the prompt, copy the drivers (AAR81XX.DDI, AAR81XX.HAM)
to:
c:\NWSERVER\DRIVERS\XXXX
where XXXX is the name of the driver.
3. Restart your system.
Installing the Device Drivers
1. Start the NetW are hdetect utility program. From the system console, type the
following, then press
Enter
: load hdetect
2. Insert the HostRAID driver disk for Novell NetW are into the floppy disk drive.
3. If you see the prompt Sys volume not mounted. Load driver anyway?, select
Yes,
then press
Enter
to continue.