MS-9185 Server Board
2-12
Fan Power Connectors: CPU0_FAN1, CPU1_FAN1, SYS_FAN1,
F_FAN1/ 2/ 3/ 4, REAR_FAN1
The fan power connectors support system cooling fan with +12V. W hen connecting
the wire to the connectors, always take note that the red wire is the positive and
should be connected to the +12V, the black wire is Ground and should be connected
to GND. If the mainboard has a System Hardware Monitor chipset onboard, you must
use a specially designed fan with speed sensor to take advantage of the CPU fan
control.
Important
Please refer to the recommended CPU fans at Intel
®
/ AMD
®
official website or
consult the vendors for proper CPU cooling fan.
CPU1_FAN1
SENSOR
+12V
GND
CPU0_FAN1,
F_FAN1/2/3/4,
REAR_FAN1
SENSOR
+12V
GND
SYS_FAN1
S
E
N
S
O
R
+1
2V
G
N
D
SCSI LED Connector: J1
Connect the J1 to the LED connector on the add-on SCSI adaptor and the HDD LED
will blink when add-on SCSI device is active.
PIN
SIGNAL
1
VCC5
2
SCSI LED
3
HDD LED
4
VCC5
Pin Definition
1
J1
Summary of Contents for K9SD Master
Page 1: ...i K9SD Master MS 9185 V1 X Server Board G52 S9185X1...
Page 5: ...v WEEE Waste Electrical and Electronic Equipment Statement...
Page 6: ...vi...
Page 7: ...vii...
