Fs340_02b_oi_e.docx / Nov-21
Page 12 / 49
Power Supply
The FS340 synchronizer accepts both, a 17
–
40 volts DC power or a 24 volts AC power for
supply via terminals 17 and 1. The current consumption depends on the level of the input
voltage and some internal conditions; therefore, it can vary in a range from 100
–
200 mA
(auxiliary currents taken from the unit for encoder supply not included).
Auxiliary Outputs for Encoder Supply
Terminals 2 and 18 provide an auxiliary output with approx. +5.2 volts DC (300 mA totally).
Terminals 3 and 19 provide an auxiliary output with approx. +24 volts DC (240 mA totally)
Impulse Inputs for Incremental Encoders
All input characteristics of the impulse inputs can be set by the parameter menu, for each of
the encoders separately. The unit works with quadrature information (A / B, 90°) only. In theory,
any of the following encoder characteristics would be applicable:
•
Symmetric differential signals according to RS422 standard, however 1V min. as
differential voltage.
•
TTL inputs at a level of 3.0 to 5 volts (differential, with inverted signal)
•
TTL inputs at a level of 3.0 to 5 volts (single-ended) *)
•
HTL signals at a 10
–
30 volts level
(alternatively differential A, /A, B, /B, or single-ended A, B only)
•
Impulses from photocells or proximity switches etc. providing a HTL level (10
–
30 volts)
•
Proximity switches according to NAMUR (2-wire) standard
(may need additional remote resistor)
*) requires special settings of the threshold parameters, see “Special parameters F08”
•
For trouble-free operation it is mandatory to use quadrature encoders with
channels A and B or with channels A, /A, and B, /B (90° phase
displacement).
•
Where the impulse level is HTL (10
–
30 volts) you can use either single-
ended signals (A and B only) or differential signals (A, /A, B, /B)
•
Where the impulse level is TTL or RS422, it is strictly recommended to use
symmetric differential signals (with inverted channels /A and /B).
Under industrial environment conditions, single-ended TTL signals may
cause serious problems due to insufficient EMC immunity of the signal
lines
•
All encoder input lines are internally terminated by pull-down resistors
(8.5 k
Ω
). Where encoders with pure NPN outputs are used,
corresponding pull-up resistors must be available inside the encoder or
externally to ensure proper function (1 k
Ω
... 3.3 k
Ω)
.
