8 General Operation
60
Rev. 02/2018
8.4.3
Connection
The
Connection
button in the
Start Menu
opens the
Communication Setup
view.
MOTORTECH devices preset to 250 kbit/s
For communication via the CAN bus, it is mandatory that all connected
devices use the same bit rate. MOTORTECH devices are usually delivered
with a bit rate set to 250 kbit/s. Use this bit rate in the PowerView3 as well.
The
Communication Setup
view provides the following options:
PowerView3
Changing Node ID
The factory setting for the node ID on your PowerView3 is 66. Change the node ID as follows:
1.
You can set a node ID for your PowerView3 in the
PowerView3
area using the arrow keys.
2.
Tap
Save
to confirm the setting of the node ID.
▸
The node ID of the PowerView3 is changed.
The changed node ID will be discarded if you tap
Reset
before saving or leave the
Communication Setup
view without saving.
Summary of Contents for PoewerView3
