6881038B70
July 27, 2001
21
Level III Service Manual Disassembly
Removing and Replacing the Transceiver Board Assembly
1.
Remove the battery cover, battery, and front cover as described in the proce-
dures
.
2.
Using the Torx driver and T-6 bit, remove the 6 screws shown in Figure 9. Set
the screws aside for reuse.
3.
Using the flat end of the disassembly tool, carefully pry the transceiver board
assembly from the rear housing. The board assembly should separate easily
from the rear housing.
4.
Lift the transceiver board assembly completely away from the rear housing.
5.
To replace, align the transceiver board assembly with the rear housing and
press into place.
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
010510o
Figure 9. Removing the transceiver board assembly
T-6 SCREW, 6 PLACES
REAR HOUSING
DISASSEMBLY TOOL
TRANSCEIVER
BOARD ASSEMBLY
Summary of Contents for T193
