•
MS - MS
– Your radio can communicate only with other radios within its range.
•
Gateway
– Your radio uses a gateway to communicate with the infrastructure.
•
Automatic
– Your radio uses the first available gateway for that talkgroup.
•
Specific
– Your radio uses only the Gateway with the specified Gateway address for that
talkgroup. If your radio displays
Selected Gateway: None
, press
Edit
to enter the
current gateway address.
•
Repeater
– Uses the first available repeater for that talkgroup.
•
GW + Rep
– Uses the first available gateway or repeater for that talkgroup.
•
Automatic
– Uses the first available gateway for that talkgroup.
•
Specific
– Uses only the Gateway with the specified Gateway address for that talkgroup.
If your radio displays
Selected Gateway: None
, press
Edit
to enter the current
Gateway address.
NOTICE:
When the Gateway and the Repeater cannot be communicated even
though a talkgroup to use them is configured, the radio attempts the direct MS-MS
communication.
When your radio detects the appropriate Gateway and/or the Repeater, the Gateway and/or Repeater
icons turns solid, respectively.
3.3.6
DMO Private Priority Call
The service provider may assign Pre-emptive Priority to outgoing DMO Private Calls. If this is the case,
DMO Private Calls from this radio preempt any ongoing calls (with the exception of emergency calls or
ongoing Pre-emptive Priority Private Calls) on the receiving radio, which then displays
Call-
preempted
.
3.3.7
Talkgroup for Individual Calls
Talkgroup for Individual Calls is a talkgroup that operates on a separate frequency allocated for
individual (private) calls only. Using this talkgroup optimizes frequency resources and helps not to
block other talkgroups. The only supported call types are: private calls and emergency calls (both
private and group). Use this talkgroup each time you need to make a private call.
When you select a Talkgroup for Individual Calls, your radio is not able to receive or initiate any group
or broadcast calls with priority lower than Emergency.
When you have selected a Talkgroup for Individual Calls and press the
PTT
button to start a Group
Call, the radio:
• Rejects the call
• Plays a tone
• Displays the
Individual Calls Only
message
3.3.8
Network Monitor
NOTICE:
This is a Software Selling Feature.
68015000797-EH
Chapter 3: Modes
50
