Whenever you attach an
arm/upper body trainer
(item no. 250
or 218)
to your MOTOmed viva 2 you have to extend the front leg
by approx. 15 cm/6 inches. However, please keep a minimum
insertion of the front leg of 10 cm/4 inches for optimal stability
of the MOTOmed.
Open the two screw knobs
located underneath the
arm/upper
body trainer
and swivel the
arm/upper body
trainer
clockwise by 180 degrees. After that,
tighten the screw knobs
again.
Open the screw knob
at the supporting
module
and adjust it to the desired training
height (after consultation of the doctor and
therapist).
Start of training:
Press the red “start/stop” button
(see figure 8)
and then the button “arm trainer”
. The hand grips
begin to
move slowly. Let the motor move your arms passively in a short
“warm-up” phase first.
If the hands are fixed (e.g. in the
forearm shells
) training may only
be done under supervision.
Further instructions for arm training are very similar to the leg
training (see pages 21 – 23, para. 4 to 8).
Please note that the
SymmetryTraining
for the arm trainer is not
included in the standard version but can be ordered additionally
(item no. 201).
17
3
8
16
15
13
14
14
13
12
14
1
.
2
.
3.
4
.
5.
6.
OPERATION
24
Fig.15
7133W200n_GB_0508 06.06.2008 14:24 Uhr Seite 26
Summary of Contents for viva2
