600 Line Recumbent Bike (RBK) Assembly Guide
To assemble the equipment, follow the steps in the order listed in this assembly guide. For more product information, visit us at www.precor.com.
WARNING
At least two people are required to assemble the equipment. DO NOT
attempt assembly by yourself.
We recommend you:
▪ Assemble the equipment close to where you plan to use it.
▪ Assemble the equipment on a solid, flat surface, so that it remains level and stable.
▪ Locate the equipment at least 19.7 inches (0.5 meter) away from walls or furniture on
either side of the equipment, and 19.7 inches (0.5 meter) away from objects behind or in
front of the equipment.
▪ DO NOT move the equipment without assistance.
Upright support
Side cover
Top
cover
Adjustable
foot
Bottle
holder
Seat back
assembly
Rear stabilizer
Front stabilizer
Required tools and hardware
For hardware, the US English acronym is used throughout the guide and in all localized versions.
Tools
Component Description
Quantity
Component Description
Quantity
▪ 6 mm hex wrench
▪ 10 mm hex wrench
▪ 13 mm open-end, box or
socket wrench
▪ 14 mm open-end
wrench
▪ Short 3 mm ball end hex
wrench
▪ 5/32-inch ball end hex
wrench
▪ #2 Phillips screwdriver
▪ Wire cutter
▪ Fish tape
Socket head cap screw (SHCS) /
M12 x 80 mm
2
Button head cap screw (BHCS) /
M10 x 15 mm
4
Button head cap screw (BHCS) /
M10 x 40 mm
4
Washer / 5 mm
1
Button head cap screw (BHCS) /
M10 x 55 mm
2
Hex nut / M10
2
Flat head cap screw (FHCS) / 1/4-
inch x 5/8-inch (used with console)
4
Button head cap screw (BHCS) /
M5 x 16 mm
1
Attach the stabilizers
NOTE
The front stabilizer has two wheels. These wheels help to move the location of
the bike.
To install the stabilizers:
1. Place the rear stabilizer under the bracket at the rear of the bike (Figure 1).
2. Secure the rear stabilizer using two M10 x 40 mm BHCS (Figure 2). Fully tighten using a
6 mm hex wrench.
3. Place the front stabilizer underneath the bracket at the front of the bike (Figure 3).
4. Secure the front stabilizer using two M10 x 40 mm BHCS (Figure 4). Fully tighten using a
6 mm hex wrench.
Figure 1
Figure 2
Figure 3
Figure 4
Attach the seat back
IMPORTANT
DO NOT pinch the cable during this procedure.
To attach the seat back:
1. While your assistant holds the seat back assembly, feed the heart rate sensor cable into the seat
back support through the opening at its base and then out through the opening in the handlebar
bracket (Figure 5).
2. Insert the lower front edge of the seat back assembly under the seat base.
3. Position the seat back assembly so that its four screw holes line up with the holes on the seat
carriage bracket (Figure 6).
IMPORTANT
DO NOT allow the seat to slide forward or it will pinch the cable.
4. Attach it using four M10 x 15 mm BHCS and fully tighten the screws using a 6 mm hex wrench.
Figure 5
Figure 6
