MOTOmed viva2, Instruction Manual

Page: 18 / 98

Set Up
Unpack your MOTOmed viva 2 and put it in an upright position. In
case the packaging or the MOTOmed viva 2 got damaged through
transportation, please contact your MOTOmed representative.
Unpack the operating panel, as far as it is not mounted yet, and
place it onto the fixture, so that the plug interlocks. Fix the display
module with the two enclosed screws.
If an arm/upper body trainer (item no. 250 or 218) is fitted, you
should extend the front leg by approx. 15 cm/6 inches. However,
please keep a minimum insertion of the front leg of 10 cm/4 inches
for optimal stability of the MOTOmed. In order to adjust the front leg
of the device you have to tilt the MOTOmed backwards carefully,
open the two Allen screws at the bottom of the MOTOmed viva 2 and
pull out the front leg of the device. After adjustment, please tighten
the Allen screws. You can find an Allen key at the bottom of the
device.
see page 75
see page 54
Important: pull out the
small front leg and tighten
the screws
Tilt the MOTOmed
viva2 backwards
Allen key
operating panel
plug
supporting module
plug
screwdriver and screw
SET UP, TRANSPORT 16
Fig. 3
Fig. 4
7133W200n_GB_0508 06.06.2008 14:24 Uhr Seite 18