see page 75
Safety Instructions for Troubleshooting
Only authorized qualified personnel is allowed to carry out repair works
on the MOTOmed viva2. For safety reasons it is crucially important that
the device is completely disconnected from the power supply.
In case of a malfunction that is not listed below or if you have any
questions,
please refer to the RECK customer service department
Upon requirement the RECK company can provide further technical
documentation in order to support the authorized qualified personnel
regarding adjustments, repair and maintenance.
The MOTOmed viva2 is Jerky, Runs Unevenly or
Makes Noises
Please check the following points:
1. Are the wing screws of the leg guides securely tightened?
2. Is the pedal radius set to the same level on both sides?
3. Is the pedal radius set too large for the level of mobility of the
user? This leads to an uneven user dependant run.
4. Are all Allen screws of the pedal radius quick adjustment
tightened correctly?
5. Please check your seating position and posture in front of the
MOTOmed viva 2. You should sit upright and in a straight
alignment with the MOTOmed viva 2. The distance between you
and the MOTOmed should be such that the legs are not stretched
completely at any time.
6. For stroke patients, it is possible that the pedal movement is
uneven due to the uneven sides of the body (especially when
using a low gear).
TROUBLESHOOTING
66
7133W200n_GB_0508 06.06.2008 14:25 Uhr Seite 68
Summary of Contents for viva2
