65
5
JAM 105 - Feeder Exit Jam C
This code is displayed if the exit sensor (Q7) was activated for too long: this means that
there is a paper jam between the rollers.
Actions:
-Shake papers to reduce static friction
-See Section 4 - Jam in Feeder Area
-Ensure that there are no obstructions in the paper path
Pro 385 Jam Codes (Continued)
JAM 201 - Late to Q20 from Q7
Late to Q20 from Q7 A occurs when it takes too much time for a paper to cover the
distance between sensor Q7 and sensor Q20. This means that the paper got stuck
between the rollers.
Actions:
-Check for misfeed sheets / debris under the sensor box (where Q7 is located)
-Lower FAN1 power
-See Section 4 - Jam in the Creaser
-Ensure that there are no obstructions in the paper path
JAM 107 - Exit sensor not activated
This message is displayed if the exit sensor (Q7) is not activated during the run. This
means that the paper got stuck in the feeder.
Actions:
-
See Section 4 - Misfeed/Jam in Feeder Area.
-Ensure that there are no obstructions in the paper path
JAM 106 - No Paper
No paper checks if sheets are present in the feeder during the feed process. A no paper
condition is generated if sensor Q11 cannot detect any paper.
Actions:
-Add paper and remove the error on the GUI
-Ensure that the Q11 sensor is clean
-Ensure that there are no obstructions in the paper path
JAM 202 - Q20 covered too long
Q20 covered too long occurs if the Q20 sensor was activated for too long. This means that
paper got stuck between the rollers.
Actions:
-See Section 4 - Jam in the Creaser
-Check that paper guides are not blocking paper
-Check that creaser tools are in open positions (see setting crease pressure)
-Ensure that there are no obstructions in the paper path
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
