www.miinet.com
Moore Industries-International, Inc.
- 116 -
User’s Manual
238-741-00K
May 2019
Programmable Smart HART Temperature Transmitter
THZ
3
/ TDZ
3
SECTION 6
TDZ3 Display
Condition
ERROR FEND
Communications with the front end have failed
ERROR NVMEM
Failure to restore configuration from non-volatile storage
ITRNL INVLD
Stored Factory information is invalid
ERROR CONFIG There is one or more configuration error
CORRn
WARN/ERROR
Corrosion sensor n is indicating a warning / error condition
RA n WARN/ERROR Range Alarm n is indicaing a warning / error condition
OUT SATLO / SATHI The Loop Current has reached the configured Under/ Over Range Value
and is being limited there.
CAL C ERROR
Configuration error detection when calibration attempted
CAL D ERROR
An input error was detected during calibration
Table 6.2.
TDZ
3
or THZ
3
Display Errors- System
ERROR DIAG
One or more diagnostic has failed
ERROR COP
Unit was reset due to the watchdog
ERROR RAM
The RAM Test has detected a failure
ERROR ROM
The ROM Diagnostic has detected a failure
ERROR ALU
The CPU's ALU (Arithmetic Logic Unit) Diagnostic has detected a failure
ERROR I/O
The CPU's IO Diagnostic has detected a failure
ERROR REG
The CPU's Register Diagnostic has detected a failure
ERROR SQMON The sequence monitor diagnostic has detected a failure
ERROR STACK
The Stack Monitor Diagnostic has detected a failure
ERROR ICUR
The Injection Current Diagnostic has detected a failure
ERROR SWARE General Software Fault
TDZ3 Display
Condition
Table 6.3.
TDZ
3
or THZ
3
Display Errors- Diagnostic Fails
