Moog SmartMotor SM34165MT-IP, Ethernet Ip Manual

Page: 74 / 160

Instance Attributes Semantics
Moog Animatics Class 6 EtherNet/IP Guide, Rev. B
Page 74 of 160
Attrib
ID
Access
Rule
Name
Data
Type
Description Semantics
11 Set/Get
(NV)
Last Conflict
Detected STRUCT
of: Structure containing
information related to
the last conflict detec-
ted.
Default Value: 0 ACD Diagnostic Para-
meters.
See below: Attribute
11: LastCon-
flictDetected
AcdActivity USINT State of ACD activity
when last conflict detec-
ted.
Default Value: 0 ACD activity
RemoteMAC Array
of 6
USINT MAC address of remote
node from the ARP PDU
in which a conflict was
detected.
Default Value: 0 MAC from Eth Pkt Hdr.
ArpPdu ARRAY
of 28
USINT Copy of the raw ARP
PDU in which a conflict
was detected.
Default Value: 0 ARP PDU
12 Set/Get
(NV)
EtherNet/IP
QuickConnect BOOL Enable/Disable of Quick-
Connect feature.
Default Value: 0 0 = Disable (default)
1 = Enable
13 Set/Get
(NV)
Encapsulation
Inactivity
Timeout UINT Number of seconds of
inactivity before TCP
connection is closed.
Default Value: 120 0 = disabled
1-3600 = timeout (sec)
a. The drive is shipped out-of-box with an IP Address of 0.0.0.0. This address enables DHCP support for address-
ing. The DHCP server manages the IP Address assigned to the drive. If a value other than 0.0.0.0 is assigned then
DHCP is disabled and the static IP Address is used. Assigning an IP Address of 0.0.0.0 will re-enable DHCP. Value is
formatted as an IP address entered as a string, e.g., IPCTL(0,"192.168.0.10"). By default, these values are set to 0
(i.e., "0.0.0.0")
NOTE: The drive must be power cycled or reset using a "Z" terminal window command before the new IP Address
takes affect.
Instance Attributes Semantics
Attribute 1: Status
Bits Name Description
0-3 Interface Con-
figuration Status 0 = Interface Configuration attribute has not been configured.
1 = Interface Configuration attribute contains configuration
obtained from BOOTP, DHCP or nonvolatile storage.
2 = IP address member of the Interface Configuration attribute
contains configuration, obtained from hardware settings (e.g.:
pushwheel, thumbwheel, etc.)
3-15 = Reserved
4 Mcast Pending Indicates a pending configuration change in the TTL Value and/or
Mcast Config attributes. This bit is set when either the TTL Value
or Mcast Config attribute is set; it is cleared the next time the
device starts.