Network Settings and Status Commands
Command
Description/
Parameter
Values
Non-
Volatile
Setting
RETH(5), or
x=ETH(5)
LFW firmware version
Firmware version as 32-bit interger. E.g.,
3.1.0.1 would be a value 50397185
(0x03010001).
RETH(6), or
x=ETH(6)
Network Lost user pro-
gram number
The current Network Lost program label num-
ber.
RETH(7), or
x=ETH(7)
Processor type
-1 = Failed
0 = Unknown
1 = netX 10
2 = netX 50
3 = netX 51/52
4 = netX 100
RETH(8), or
x=ETH(8)
Protocol type
0 = Not defined
1 = PROFINET
2 = EtherCAT
3 = EtherNet/IP
RETH(9), or
x=ETH(9)
Network Lost action
The current value assigned to the Network
Lost action.
RETH(14)
RETH(15)
IP address
Value is in dotted-decimal format.
RETH(16)
Subnet mask
Value is in dotted-decimal format.
RETH(17)
Gateway
Value is in dotted-decimal format.
RETH(18)
MAC ID string format-
ted report only
E.g., 00:01:02:a9:ff:00
RETH(30), or
x=ETH(30)
I/O read data size
Value is configured by the master.
RETH(31), or
x=ETH(31)
I/O write data size
Value is configured by the master.
RETH(45), or
x=ETH(45)
IP address as integer
E.g., for an IP address of 192.168.1.3 (C0 A8
01 03 hex), this command reports -
1062731517 (it reports as a 32-bit signed
value).
RETH(46), or
x=ETH(46)
IP subnet mask as
integer
E.g., for an IP netmask of 255.255.0.0 (FF FF
00 00 hex), this command reports -65536 (it
reports as a 32-bit signed value).
RETH(47), or
x=ETH(47)
IP gateway as integer
E.g., for an IP gateway of 192.168.1.1 (C0 A8
01 01 hex), this command reports -
1062731519 (it reports as a 32-bit signed
value.)
RETH(48), or
x=ETH(48)
Low 3 bytes of MAC ID
(device ID) as integer
E.g., for a MACID of 00:01:02:a9:ff:00, this
command reports 11140864 (00 a9 ff 00 hex)
RETH(49), or
x=ETH(49)
High 3 bytes of MAC ID
(device ID) as integer
E.g., for a MACID of 00:01:02:a9:ff:00, this
command reports 258 (00 00 01 02 hex)
RETH(50), or
x=ETH(50)
Internal error code
For details, see Status and Diagnostic Codes
on page 41
RETH(51), or
x=ETH(51)
Internal error source
For Moog Animatics use.
RETH(54), or
x=ETH(54)
Initialize error code
For details, see Status and Diagnostic Codes
on page 41
ETHCTL(3,x)
Reset
Resets Stack Fault code RETH(3) to 0
Moog Animatics Class 6 EtherNet/IP Guide, Rev. B
Page 39 of 160
