RP424PFC Indoor Gas Fireplace
Page 52
XG0781 - 151104
Operation
Section 12: Operation
Refer to
Figure 106
for lighting instructions. This can also be found
inside the control box.
Operating the fireplace
The
RP424PFC
is controlled using a basic ON/OFF wall switch or
by using the optional remote control.
When placed in the ON position:
The blower will initialize.
After approximately one minute the igniter will start to glow and
the pilot will light, followed by the main burner.
When placed in the OFF position the flame will turn off and the blower
will continue to run for three minutes to purge any remaining exhaust
gas from the system.
If the fireplace does not light after three attempts it will go into a safety
lock-out mode. After five minutes the fireplace will attempt to light
again. If the fireplace will not light, turn the fireplace off, turn off all
electrical power to the appliance, locate the gas shut off valve and
turn the gas off. Call your service technician or local Montigo dealer.
Never attempt to light the pilot by hand.
This fireplace includes a glass barrier which helps prevent injury
from burns. Never operate this appliance without all three layers
of glass installed. Children and other at risk individuals should be
monitored at all times.
Operating the accent lights
The accent lighting is operated by a separate ON/OFF wall switch.
If the fireplace is NOT burning
Turn the accent light ON/OFF wall switch to the ON position to
power the lights on.
The blower will start.
After 60 seconds the lights will come on.
After another three minutes the blower will turn off.
If the fireplace is burning
Turn the Accent light ON/OFF wall switch to the ON position to
power the lights on.
After 60 seconds the lights will come on.
The fireplace will continue to operate normally.
Refer to
Replacing Light Bulbs
for information on the replacement
of the halogen bulbs.
