Page 26
XG0526-151109.2
I-Series Indoor Gas Fireplace
Installation
Figure 51 Sec.4
Figure 52 Sec.4
Figure 53 Sec.4
Figure 54 Sec.4
Figure 55 Sec.4
4)
Temporarily, place the Electrical Cord through the hole in the
right side of the Rear Faceplate
5) Attach the Rear Faceplate to the Firebox using the screws
provided (18 locations). Do not insert screws in magnet locations
highlighted in Figure 53 below.
6) Install the four Front Faceplate Retainer Magnets using
screws provided as shown (8 locations). Note proper orientation
of magnets.
7). Remove the twist tie and Zip Strap that is on the On / Off
Switch wire harness.
8). Slip the Split Plastic Grommet, found in the plastic bag attached
to the master override switch, around the Power Cable and then
press it into the provision on the right lower side of the Rear
Faceplate to secure the Power Cord.
9). Thread the On/Off Wire Harness through the gap between the
Control Board Mounting Bracket and the Rear Faceplate Panel.
Figure 56 Sec.7
