Page 30
XG0526-151109.2
I-Series Indoor Gas Fireplace
Installation
10). Place the Zip Strap through the hole in the Plastic Stick on
Retainer on the back of the Rear Faceplate. Zip the wires together
in one tidy package as shown.
Figure 74 Sec.4
11). Place the master override switch in the OFF position. Until
the remote is synced to the control board, this switch acts as a
master. If you apply gas and power to the unit while this switch is
in the ON position, it will initiate lighting.
Figure 75 Sec.4
13). Install the Front trim. It has two hooks at the bottom which
must be engaged on the bottom right and left of the Front Faceplate
(see Figure 77 Sec.4). Magnets hold it at the top right and left.
Figure 76 Sec.4
14) Hooks to secure the Front Faceplate are at the bottom left
and right.
15). Trim installation completed. Make sure it is securely in place.
Figure 77 Sec.4
(unpainted shown for illustration)
Figure 78 Sec.4
12). At this stage it is easiest to install the batteries. See section
on battery installation and replacement.
