Monet DESAUW FWA500, Manual

Page: 26 / 85

Using a framing square, measure from the bottom of the
board to the BOTTOM of the cut. The measurement should
be ¾”. If it is not, raise or lower the blade until it is ¾”.
Recut the board until you achieve this measurement.
The moveable end should look like this:
Using a framing square, measure from the bottom of the
board to the TOP of the cut. This should be ¾”. If it is not,
raise or lower the blade until it is ¾”. Recut the board until
you achieve the measurement.
Next, set each side at 45 degrees and make a cut.
The points where the blades intersect should be ¾” from the
bottom of the board, DO NOT measure from the top of the
board as board thickness may affect an accurate center line
adjustment.
22
2
3
4
Upper Conveyor /
Hold-Downs