Monet DESAUW FWA500, Manual

Page: 23 / 85

Installation
1. Set the saw in place, hook up power in the fixed end cabinet
(wire can enter the cabinet either in the top or bottom)

480-volt, 3 phase, 60 hertz, 60-amp wye connection

DO NOT USE CONDUIT FOR A GROUND
2. Turn power on the saw and test for proper voltage – leg to leg
(460-480), and leg to ground (277) on each phase
3. Hook up air connection to side of air brake box

50 psi @ 1-2 CFM

Once air is applied, the brake should be pressed against the
blade
4. Level the saw, ensuring all 4 legs of the saw frame are on the
ground, shim as necessary to ensure all legs are firmly on the
ground

There is no need to anchor saw to the ground
5. Slide shaker under saw to desired direction

Anchor the shaker using 3/8 x 4 anchors in CONCRETE only
– No asphalt

Draw the anchors tight only if frame is setting flat on ground
– if there is a gap between frame and floor you must place
shim material between floor and frame, otherwise the
fiberglass paddles will break over a period of time
19