PRIME TR3000
48
ENGLISH
Belt Lubrication
Use only 100% Silicone and avoid using aerosol silicone sprays which include additives and petroleum distillates.
One ounce of Silicone should be used for each application.
The running belt should be lubricated every 3 months (regardless of use) or every 50 hours of use, whichever
comes first. Even if the treadmill is not being used, silicone will dissipate over time and the belt will dry out.
Note: Even though the running belt is lubed from the manufacturer, you should lubricate the running belt when
first using the treadmill in case the belt has dried some between the dates the unit was manufactured and when
it was purchased.
The Silicone icon will turn on in the display every 100 hours of use and is a reminder that it is time to lubricate
the running belt. As indicated above it is best to lubricate the running blet every 50 hours of use. This is a remin-
der for the 2nd 50 hours. The icon will be in the display for 5 minutes and then it will turn off. To turn the icon off,
before the 5 minutes, you can press the Speed Down and Start buttons simultaneously until the icon turns off.
Apply the silicone to the underside of the treadmill belt. Do not apply to the walking surface. This may be ac-
complished by standing up the treadmill and applying the silicone to the inside portion of the belt. Spray the
silicone down and across the belt. Rotate the belt ½ of the circumference and repeat. About the one ounce of
Silicone should be used for each application.
Note: When lubricating the belt, make sure the treadmill is located on a surface that can be easily cleaned. After
lubricating your treadmill running belt, clean any excess silicone off the belt and frame.
Cleaning and Maintenance
It is recomendend to wipe the treadmill down after each use to keep the treadmill clean and dry. A mild deter-
gent may be used at times to help remove all dirt and salt from the belt, painted parts and the display.
The maintenance icon shows up in the display every 150 hours of use. This is a reminder to claen the unit really
well. This cleaning would include removing the motor cover and cleaning around the motor and electronics. It
is recommended to clean the motor compartment if the treadmill is in an area where three might be a lot of pet
hair or plush carpet fibers that could get pulled up into the motor compartment. It is a good idea at this time to
check and tighten all assembly hardware as well.
Warning: Unplug the power cord before removing the motor cover.
After cleaning and checkin all assembly hardware, turn the maintenance icon off, by pressing Speed Down and
Start buttons simultaneously until the icon turns off.
