PRIME TR3000
52
ENGLISH
Troubleshooting
The treadmill is designed and manufactured to be reliable and easy to use. However, if you have a problem,
these troubleshooting steps may help you find the cause.
Problem:
The console is erratic or not lighting up.
Solution:
Check to make suire that the treadmill is properly plugged in, turn the power switch off and
back on again and make sure the safety key is in place. Check all wire harness connections to be
sure they are all properly connected. If the problem still persist contact Monark
Costumer
Service
Problem:
The belt does not stay in the center of the treadmill when in use.
Solution:
First check to make sure that the treadmill is level, then refer to the instructions in this manual
on how to tension and adjust the belt.
Problem:
The treadmill motor seems strained or E1 comes up after several minutes of use..
Solution:
The lubricating silicone that is applied to the deck and belt is wearing down and the blet needs
to be lubricated with silicone spray.
Problem:
The treadmill belt slips during use.
Solution:
The blet may need to be tensioned after a period of use. Refer to the Belt Tensioning and Adjust
ment Section of this manual.
Problem:
Heart Rate is erratic or not picking up.
Solution:
Make sure your hands are moist (Aloe vera helps). Make sure all connectors at the back of the
console are properly connected and no wires are damaged. If wearing a chest strap make sure
the batteries are good and that the electrodes are moist and postioned properly on your chest.
Problem:
Treadmill automaticaly pauses during workout.
Solution:
Treadmill is not picking up Step Count. Go into Engineering Mode to turn intelli-guard off.
Warning: This will disengage the intelli-guard feature but may be necessary based on many dif
ferent
vaiables.
Problem:
Silicone icon lights up on console.
Solution:
Lubricate the running belt with 100 % pure silicone. Then simultaneously press and hold the
Speed down and Start buttons until the lights turns off.
