Monarch NICE 5000, User Manual

Page: 43 / 233

3 Mechanical and Electrical Installation NICE5000 User Manual
- 42 -
Mark Terminal Name Function Description
Terminal
Arrangement
CAN
CANbus
communication
indicator
This indicator blinks when
communication between the
CTB and the MCB is normal,
and is steady on when a
communication fault occurs.
CAN
RESET
RESET
CANbus
communication fault
indicator
This indicator blinks and
the CANbus communication
indicator is steady on
when a fault occurs during
communication between the
CTB and the MCB.
X1 to X8 DI indicator
This indicator is on (green)
when the external input is
active.
X1 X2 X3 X4
X5 X6 X7 X8
A1, B1 to B3, C1 to
C3,
D1 to D2
Relay output
indicator
This indicator is on (green)
when the system output is
active.
B1 B2 B3
C2
C1
D2 D1 C3
A1
J9 Reserved
It is factory reserved. Do not
short it randomly. Otherwise,
the controller may not be used
properly.
-
Note
• To prevent external interference on communication, you are advised to use the shielded twisted
pair as communication cables and lay them parallel.
• Connect cables to the terminals according to the terminal marks, and fix the cables.
3.4 Display Board (MCTC-HCB)
As an important interface between users and the control system, the MCTC-HCB receives
hall calls and displays the current floor and running direction for the hall. This board can also
be used as car display board.
Monarch provides many types of display boards. The following part describes only a
few common types. If the types available cannot meet your requirements, you can use a
parallel-serial conversion board (HCB-B) to make the board provided match your own. For
any further requirement, contact us.
The common types to be described are listed in the following table.