Monarch NICE 5000, User Manual

Page: 175 / 233

NICE5000 User Manual 7 Description of Function Codes
- 173 -
parameter indicated by each bit circularly.
Figure 7-6 Shift between parameters displayed in the running state
Logic information
Curve information
Pre
-torque current
Feedback speed
Bus voltage
Output voltage
Output current
Output frequency
Torque current
Output power
Speed reference
Output torque
Shift between parameters
displayed in the running state
Present position
Car load
Encoder interference
Communication
interference
Bit0 Bit1 Bit2 Bit3 Bit4 Bit5 Bit6 Bit7 Bit8 Bit9 Bit10 Bit11 Bit12 Bit13 Bit14 Bit15
Function Code Parameter Name Setting Range Default Unit Property
FA-02 Display in stop state 1–65535 4095 -
☆
It is used to set the running parameters displayed on the operation panel when the elevator
is in the stop state.
FA-02 includes 16 binary bits, each defining a parameters. A total of 16 parameters can be
can be displayed at stop.
The 16 binary bits correspond to the parameters listed in the following table.
Bit Parameter Name Default Bit Parameter Name Default
Bit0 Rated elevator speed 1 Bit8 Encoder signal 3 1
Bit1 Bus voltage 1 Bit9 Encoder signal 4 1
Bit2 Current floor 1 Bit10 Encoder signal 5 1
Bit3 Current position 1 Bit11 Encoder signal 6 1
Bit4 Car load 1 Bit12 Reserved 0
Bit5 Slow-down distance 1 Bit13 Reserved 0
Bit6 Encoder signal 1 1 Bit14 Reserved 0
Bit7 Encoder signal 2 1 Bit15 Reserved 0
The method of setting and viewing FA-02 is similar to that of FA-01.