Monaco Executive 2005, Owner'S Manual

Page: 315 / 538

LP-Gas Systems --- Section 7
The Executive 2005
315
If A Freeze Up Occurs:
• Have an LP-Gas distributor purge the tank.
• Have the LP-Gas distributor inject methyl alcohol in the tank.
Damage to the regulator can occur when the tank is overfilled. The regulator is designed to work
with vapor only. This is why the tank is filled to only 80% of its liquid capacity. The other 20% allows
for vaporization of the liquid. The primary vapor valve is located in the vapor section of the tank. In
an overfilled tank, liquefied petroleum can fill the regulator. As the liquid vaporizes, it can freeze the
diaphragm. High tank pressure on a frozen diaphragm can cause a rupture and result in erratic pressure
regulation. This is why it is important to have the LP-Gas pressure checked for proper pressure and
accurate regulation during appliance operation. Erratic pressure regulation dramatically affects refrigera-
tor operation on LP-Gas.
Manometers:
The manometer is the best way to accurately determine
LP-Gas pressure. There are two different styles of manometers:
Gauge and U-tube. Gas pressure is measured in Inches of
Water Column. This is the amount of pressure applied to
one side of a U-shaped tube half filled with water. The amount
of pressure needed to raise the column of water
11" represents
11 Inches of Water Column .
WARNING:
Do not attempt to adjust the regulator. Adjustments
require special equipment. Failure to follow these
instructions may result in a fire or explosion, and can
cause severe personal injury or death. Do not oper-
ate LP-Gas appliances until the LP-Gas pressure is
checked and a leak down test is performed!
050260
050259a
Manometer Gauge for Testing
Type 1
Manometer at Rest
Type 2
U-Tube Testing Layout