Monaco 2008 Knight, Owner'S Manual

Page: 82 / 246

applIances —
8
2 0 0 8 K n I G h t
Exterior Refrigerator Access Panel
NOTE
Ensure the exterior refrigerator
access panel is properly replaced after
removal.
Air in LP-Gas Supply Lines
For safety reasons, the refrigerator will
attempt to ignite on propane gas within a
specified amount of time. When starting the
refrigerator for the first time after storage, or
after servicing the gas supply system, propane
gas supply lines may contain air. Due to the
air in the gas supply lines, the refrigerator may
not ignite on propane gas within the specified
amount of time. Follow the procedure on how to
remove air from the LP-Gas supply lines.
To remove the air from the LP-Gas supply lines:
Ensure the primary LP-Gas valve and
any other necessary valves are open.
Try lighting the cooktop burners first
to quickly purge air from the main
distribution line.
Push the
ON / OFF button to turn the
refrigerator on.
Press the
MODE button until the
refrigerator indicates LP. The refrigerator
will start a 30 second trial for ignition
during which the gas safety valve opens
and the igniter sparks.
If the refrigerator fails to light, indicated
by
F or NO FL (No Flame) , turn the
refrigerator OFF then back ON and set
to LP mode
. If after the third attempt
the refrigerator fails to light, stop and
consult your local dealer or an authorized
Norcold Service Center.
Control Panel – Two Door (Optional)
ON/OFF Button – Turns the refrigerator
on or off.
AUTO/STORE Button – Used to select
energy mode between AUTO AC, AUTO
Gas, or LP-Gas. The AUTO/STORE
button is also used to save settings.







LED Display – The screen displays
temperature, different modes of
operation, and status messages:
- Temperature in frozen food compartment.
- Temperature in fresh food compartment.
- AUTO AC mode.
- AUTO Gas mode.
- LP-Gas mode.
- Temperature setting.
- Clock.
- Status and error messages.
SET Button – Used to adjust the
temperature range and to set the clock.
Starting Up:
Press the main power ON/OFF button. If the
clock has to be set the LED display will show
flashing horizontal bars “-- --“.
WARNING
Before starting the refrigerator,
check that all gas valves are in the
ON position, this includes the shut off
valve in the rear of the refrigerator.


031217
031223
031222
031224
Ensure latches
are in the locked
position.
Ensure tabs are
inserted.