Monaco 2008 Knight, Owner'S Manual

Page: 123 / 246

2 0 0 8 K n I G h t
119
2 0 0 8 K n I G h t
equIpment —
NOTE
For the bedroom dash radio switch to
function the dash radio must be on.
Home tHeatre SUrroUnD SoUnD
The Home Theatre Surround Sound System
has speakers located throughout the living room
area. The system operates from 12 Volt DC
powered from the coach batteries or the inverter.
Home Theatre Surround Sound operates through
the DVD player only. Surround Sound is not
capable through the dash radio or bedroom
speakers.
Speaker Switch
A Speaker switch is located in the
overhead compartment above the
driver’s seat.
Place switch in Home Theater
position for Surround Sound.
Dash Radio position turns sound
OFF.
Remote Control
The remote control can be used to perform
many entertainment functions.
Requirements for Remote Control
Operation:
Batteries in remote control are operating
and charged
Infra-Red transmitter must be connected
into the Infra-Red input on the DVD
player.




Remote control must be
pointed at the Infra-Red eye
above the Main TV to perform
functions.
NOTE
Overhead lights can affect the Infra-
Red eye’s ability to receive a signal from
the remote control. If a problem exists
turn lights off one-by-one until remote is
performing functions.
BeDroom DvD (optIonal)
The bedroom DVD player has many features
including multi-format playback for movies,
photos and music and progressive scan for
enhanced picture quality.
Requirements for Operation:
House battery disconnect switch must be
On.
Battery cut out switch must be On.
INFORMATION
For more detailed operating information
refer to the bedroom clock player OEM
manual.




SatellIte SyStem
DSS Prewire
The motorhome is pre-wired with two (2) RG6
cables that route from the satellite prep plate
connections ROOF LNB #1 and ROOF LNB #2
to an area above the first ceiling light. One cable
RG6 routes to the driver’s side rear compartment
while the other cable RG6 coax routes to the rear
bedroom receiver location.
The motorhome also has telephone lines which
route from the driver’s side rear compartment to
each satellite receiver location: main TV and rear
bedroom.
All cables are attached to the satellite prep
plate located in the overhead cabinet above
the driver. These include ROOF LNB #1 and
ROOF LNB #2 to the roof satellite dish, exterior
dish, to the cable plate in the drivers side rear
compartment, rear receiver to the rear bedroom
interface plate, and receiver #1 out to the switch
box as satellite in.
The following corresponds to the connections
on the front of the Satellite Receiver Connection.
FROM EXT DISH:
Hook-up to a
portable satellite dish. Run a coaxial cable from
this connection to Satellite In.
031066n
031193e
Infra-Red transmitter plugged in
031193f
Infra-Red eye
by TV
031242b
031070d