Monaco 2008 Knight, Owner'S Manual

Page: 118 / 246

equIpment —
11
2 0 0 8 K n I G h t
Trip Meter Selection
Trip Meter
Selection provides
trip information for
up to 10 different
trips, plus dedicated
trip leg status and
fuel status screens.
Trip screens selected
are independent
of each other and can be started, paused,
resumed, cleared, and provide time and distance
information as well as average speed and fuel
mileage.
Trip Leg Statistics gives trip information, plus
distance-to-go and time-to-go based on trip leg
averages.
The Fuel Tank Statistics provides such
information as estimated fuel remaining and
range based on current averages.
Changes made
to any of the Trip
Meter selections,
with the exception of
clearing a numbered
trip, should be done
while the ignition is
on to enable Aladdin
to collect necessary
information from the engine. The last available
information will be used if the ignition is off
when changes are made.
The status screen display may take several
minutes after a change is made before it starts
updating values. In the case of Duration, the
display will not update for approximately six
minutes because Duration is displayed to the
tenth of an hour (six minutes).
The Aladdin requests engine statistics
periodically from the engine for use with trip
calculations. After such a change the next
valid engine data will not be available for
approximately one minute. The rate of data
change is also influenced by motorhome speed,
fuel rate, and time.
Select Video Source
Use this screen to
access the optional
Navigational screens.
Time and Alarm Functions
Time and Alarm
Functions allow the
operator to view the
current time, set the
date and time, set
alarms, and change
the sound of the
alarm.
System Options
System Options
provides a submenu
for Aladdin functions
that are less frequently
used such as how
to adjust screen
appearance.
Only
service personnel
should access System Setup.
Compass
Calibration: Compass
calibration allows
the operator to either
calibrate the compass
or enter declination.
Calibration will
compensate for metal
construction within
the motorhome and increase accuracy. Entering a
declination will allow for true North or magnetic
North compass headings.
Calibration is accomplished by selecting
Start Calibration, then driving in a full 360º
circle. At the end of driving this loop, select
Stop Calibration. A successful calibration will
cause a “Calibration Successful” message to be
displayed. A calibration that fails will display
“Calibration Fail” along with a failure code.
020200b
020195s
020195t
020195u
020195m
020195r