equIpment —
10
2 0 0 8 K n I G h t
NOTE
When retracting the slide-out, stop the
room approximately halfway. Confirm
that the fabric is properly rolling before
fully retracting the slide-out.
CAUTION
The slide room and slide-out awning
should be retracted before heavy wind,
rain or snow to prevent damage to the
awning or motorhome. Wind can drive
rain under the slide-out awning and into
the motorhome.
CAUTION
At least five feet of clearance is needed
between the side of the motorhome and
any objects, such as trees or fences,
to allow the slide room and slide-out
awning to fully extend.
CAUTION
Rain water can pool on the slide-out
awning. The added weight will cause
the awning to sag. Upon retracting the
room, material can become caught in
between the top of slide room and the
opening in the motorhome. It will be
necessary to retract the room in small
increments and allow the water time to
run off.
Front Door - Mirage
The Mirage awning operates on 12 Volt DC by
the push of a button to extend the awning to its
full extension.
To Operate:
Check for sufficient clearance
before extending the awning.
Chassis battery disconnect
switch must be on.
Turn the ignition switch OFF.
Push the Door Awning Extend/
Retract button and hold. When
desired extension is reached,
release the button.
To close, push the Door Awning Extend/
Retract button and hold to retract the
awning to its travel position.
If the awning fails to operate:
Ensure ignition is off.
Check power at 15 Amp circuit breaker
in front electrical panel in roadside front
compartment.
NOTE
See awning OEM manual for detailed
operation instructions.
Window Awning
To Extend
the Window
Awning:
Hook loop of
pull strap with
catch rod and
pull awning,
reel assembly
and side arms
to extend fully
away from motorhome.
Hook pull strap on side strap hook,
remove catch rod from pull strap and
store.
To Retract the Window Awning:
Hook catch rod on pull strap, remove
pull strap from side strap hook and
slowly allow awning to retract.
Remove catch rod from pull strap and
store for future use.
Patio Awning - Eclipse
The Eclipse awning operates on 12 Volt DC by
the push of a button. The awning requires 10’ of
lateral side clearance.
To Operate:
Turn the ignition switch
OFF.
Check for sufficient
clearance before
extending the awning.
Chassis battery
disconnect switch must be ON.
Turn the Awning Power On/Off button to
ON .
Push and hold the Extend/Retract button
to extend the awning. Release the button
at any time for partial extension.
Push the Extend/Retract button and hold
to retract awning.
060313f
030792
030581b
060313g
Summary of Contents for 2008 Knight
