167
2008 knight
elecTrical sysTem - house — 8
6. Push bulb in and rotate to lock position.
7. Gently squeeze lens cover and insert
tabs on cover into fixture.
CAUTION
Do not touch the incandescent bulbs
while it is on. Allow bulb to cool down
before replacing because a hot bulb can
cause a burn.
Interior Halogen
To Remove:
1. Grasp light fixture and pull down
slightly then tilt fixture to one side.
This will allow one spring clip to come
out.
CAUTION
Push spring clip inward with a finger as
clip is being eased out. If this is not done
spring clip can snap back on fingers.
2. Tilt fixture to other side
and ease the other spring
clip out.
3. Unscrew the light lens
counterclockwise and
remove.
4. Carefully grasp bulb
and pull from socket.
Replace with the same
type of bulb.
5. Use a clean cloth or piece of tissue to
grasp new bulb. DO NOT touch bulb
directly as this can cause a “hot spot”
and result in immediate bulb failure.
6. Align contacts of bulb with terminals in
fixture base. Insert bulb until contacts
are firmly seated.
To Reinstall:
7. Align tabs on light lens with slots in
fixture base. Rotate lens clockwise
until light lens locks into place.
8. Fold up both spring clips and insert
light fixture into opening. Once in
opening the spring clips will expand
and lock light fixture into place.
CAUTION
DO NOT touch halogen lighting while
on. They can cause a burn. DO NOT
touch replacement bulbs. Oil in the
hands can cause a “hot-spot” to occur. If
the bulb is touched, allow it to cool and
clean the bulb with alcohol.
Fluorescent Light
Operation:
Turn the fixture On/Off by
pressing the power switch on the side.
To Remove a Fluorescent Tube:
Make sure light fixture is Off.
Carefully squeeze both sides of lens
cover. The cover has a groove on each
side that fits into guide rail. Remove lens
cover.
Grasp the fluorescent tube with both
hands and rotate so that the prongs are
facing straight up in the socket slot.
Carefully remove tube.
Replace with Philips TL 8W/33T
fluorescent tube
NOTE
Replacement tube number is accurate
at the time of printing. Confirm
replacement tube number before
ordering or obtaining replacement.
To Replace a Fluorescent Tube:
Align the prongs on the fluorescent tube
with socket slot.
Insert tube and using both hands rotate to
seat.
WARNING
Fluorescent bulb must be fully seated
for proper operation.
Insert one groove on the lens cover into
the guide rail.
Carefully squeeze lens cover to insert
other groove into guide rail.
CAUTION
DO NOT touch fluorescent tubes while
they are on. Make sure tubes are cool
before handling.
060200d
Summary of Contents for 2008 Knight
