Monaco 2008 Knight, Owner'S Manual

Page: 114 / 246

equIpment —
110
2 0 0 8 K n I G h t
To Operate Air Mattress:
The air mattress requires 120 Volt AC power
from shore power or the generator to operate.
The inverter can be used, but battery power may
be depleted by continued use.
Ensure the battery-cut out switch is on and the
house batteries are charged.
What is a Sleep Number:
It is a setting between 0 and 100 that
represents the ideal combination of
mattress comfort, firmness, and support
for each person’s body.
Use the initial Sleep Number on the
remote as a starting point.
Setting the Sleep Number:
1. Lie on the bed in a normal sleep
position.
2. Press and release any remote button
to display the current Sleep Number
setting.
3. To change setting, press the firmer or
softer buttons until desired comfort
setting is achieved.
4. Remain still until the number change is
complete.
5. When adjustment is complete, the Sleep
Number will stay lit for five seconds
and then the display will turn off.
NOTE
Finding the ideal Sleep Number may
require experimenting with different
settings.


Mattress Care:
The cover may be spot cleaned with
carbonated water or mild detergent.
DO NOT
dry clean the mattress cover or put it in a
washing machine.
DO NOT apply a stain-guard,
as this may cause yellowing of the fabric.
In rare instances, under the right conditions,
mold or mildew may form inside mattress or
bedding. If this occurs call the manufacturer’s
customer service department at 800-318-2231.
Mountain Traveling:
If traveling into a mountainous region, either
(1) temporarily disconnect the mattress from the
pump hose to allow air escape or (2) partially
deflate the mattress chamber to a Sleep Number
of 20.
WARNING
Rapid changes in altitude will effect
the air pressure inside the mattress.
The chamber may be damaged if the
pressure becomes too great.
NOTE
For more detailed information consult
the OEM manual or call 800-318-2231.
free StanDIng DInette (optIonal)
The free standing dinette comes with two
standing chairs and two folding chairs.
To Extend/Retract Table:
To extend, pull out on table until it locks
completely out.
To retract, push in on table until it locks
completely in.
WARNING
Only forward facing booth dinette seats
equipped with seat belts are designed
for occupancy while the motorhome is in
motion. DO NOT occupy dining chairs
while the motorhome is in motion. To
avoid injury in case of a crash or sudden
stop, chairs should be stored in an
enclosed area or secured with tie down
straps.
arcHeD Back BootH DInette
Bed Conversion
For Bed:
Remove the seat cushions. This allows
the table to move down into the bed
position.
Under the table locate the
button lock found on front
bracket. Push button to
unlock leg. Swing leg up.




031273
Table does not retract
completely
020163g