Monaco 2008 Knight, Owner'S Manual

Page: 116 / 246

equIpment —
112
2 0 0 8 K n I G h t
cItIzen BanD (cB) raDIo - prep
A two pin connector labeled Citizens Band
Radio is located behind the dash panel, along
with the CB Antenna coax, which is routed to the
roof mounted base. The red wire is + 12 Volt DC
(positive) and has a two amp fuse in the front
distribution panel. The white wire is connected
to the frame (ground).
gpS navIgatIon (optIonal)
The GPS Mobile Navigation system provides
2-D and 3-D map views, instant re-routing and
turn-by-turn instructions. The system includes a
GPS antenna, a DVD ROM player and a DVD
map of the US and Canada.
CAUTION
For safety, only perform GPS operations
when motorhome is parked.
INFORMATION
Complete information and instruction
are found in the OEM manual.
SatellIte raDIo (optIonal)
The satellite radio is a digital signal decoder
and tuner. Signals are transmitted from a ground
station to satellites orbiting over the continental
United States. The satellite then transmits the
signal to an antenna in the motorhome. The radio
receiver decodes the transmission and plays
the selected channel within that transmission.
Signals are also transmitted to ground repeaters
for listeners in urban areas where the satellite
signal can be interrupted.
NOTE
For information regarding subscriptions
and service coverage areas, contact the
appropriate provider for the system.
Sirius® Radio
1-888-539-7474
www.siriusradio.com
INFORMATION
For detailed information and operating
instructions on the satellite radio, refer
to the OEM manual.
alaDDIn™ SyStem (optIonal)
The Aladdin™ system is designed to
monitor various chassis and electrical systems
providing up to date and accurate information.
Chassis information comes from the engine
and transmission electronics. This allows the
operator to make informed decisions regarding
operation of the motorhome.
Aladdin™
Controller:
The controller allows
the operator to control
cursor movements.
Press the select or
right button to enter
a screen.
Press the left button
to return to the
previous screen.
Press the up or down buttons to scroll
through or change information.
LED Indicator:
An LED provides system-on power indication.
The LED blinks whenever the controller is used.
The LED will blink every few seconds when
the Aladdin™ system is powered on. Pressing
the select or left button on the controller will
activate the system and the LED will turn on.
Select Buttons:
Two select buttons are used for operation. One
is found on the Aladdin controller, the other on
the Voyager monitor. To avoid confusion they
will be referred to as (Aladdin) select button and
(Voyager) select button.



031219c
Located in driver overhead compartment
080377f