Monaco 2008 Knight, Owner'S Manual

Page: 48 / 246

drIvInG & safety — 2
2 0 0 8 K n I G h t
Smoke Detector
Statistics show that most fire casualties are not
caused by direct flame, but by less visible smoke
(products of combustion). The smoke detector
automatically returns from alarm to normal state
when the reason for activation, the presence
of smoke, is completely removed. Fires are
commonly caused by smoking in bed, leaving
children unattended or using flammable cleaning
fluids. Please be safety conscious and avoid
unnecessary risk.
WARNING
There is no way to insure against
injury or loss of life in a fire; however,
the smoke detector is intended to help
reduce the risk of tragedy. Additional
smoke detectors may help to reduce the
risk. Proper use and care of the smoke
detector could save lives.
Operation
When a 9 Volt DC battery is correctly
connected, the LED flashes every minute and
a loud alarm will sound when a product of
combustion is sensed.
NOTE
The unit will not operate without
a battery. A battery flag pops up
preventing the unit from being installed
to the mounting bracket without a
battery. Carbon zinc batteries average a
service life of one year. Alkaline batteries
average a service life of one to two years.
Testing
Simply press the test button on the smoke
alarm cover for approximately three seconds.
The alarm will sound if all electronic circuitry,
horn and battery are properly working. The
smoke alarm should be tested at least once a
week when the motorhome is in use, prior to
each trip and when the motorhome has been
in storage. When testing the smoke alarm it is
advised to stand at arm’s length.
CAUTION
Never use an open flame to test the
smoke alarm as this may ignite the
alarm or surrounding area and set fire
to the motorhome.
Maintenance
Maintenance for Proper Operation:
Test the smoke alarm once a week.
Keep a supply of 9 Volt DC batteries on
hand.
Vacuum the slots in the cover and sides
with a soft brush attachment every
month. Test the smoke alarm after the
unit has been vacuumed.
The smoke alarm will beep once a
minute when a low battery exists.
Replace battery immediately.
Troubleshooting
If the alarm does not sound when the test
button is pushed, or with a smoke test, try the
following:
Inspect
alarm for obvious damage.
Check for the recommended battery type.
Check the battery for proper connection
or replace the battery if needed.
Gently vacuum as recommended.
If these procedures do not correct the problem,
DO NOT
attempt repairs. If the smoke alarm is
within the warranty period and the terms indicate
the nature of the problem, return the unit to your
dealer. Smoke detectors beyond the warranty
period cannot be economically repaired.








020123
Located on ceiling in
main living area