Mocon AMETEK Dansensor MAP Check 3 Vacuum, User Manual

Page: 65 / 92

Dansensor
®
MAP Check 3 Vacuum EN User Guide 63
P/N 320598-G
11/2019
Data log setup
Selecting Data log setup from the General setup menu will display a screen showing the
parameters for the data logging function.
Log interval Set the number of cycles for which the device should log data.

If set to 1, data is logged for all cycles.
Log all alarms No Alarms occurring in the period between logs

as set in "Log interval" are not logged.
Yes All alarms are logged.
Logging enabled No No logging of data
Yes Logging of data enabled
Logging mode Last values Ring buffer of specified number of log entries.

Normally this is best setting for On-Line

equipment due to the continuous operation.
Until memory full Logs data until memory is full, then stops

logging until data has been exported and/or

deleted.
Log last values Set number of log entries in the data log ring buffer

(Only appears when “Logging mode” is set to “Last values”)
Network logging Select whether or not network logging is required.
No No network logging
Yes Network logging enabled
(Below parameters only appears when “Network Logging” is set to
“Yes”).

Network logging Select required data logging output format:

mode Compatible (Default)

Data format as used on devices

with firmware versions < 4.2.0.

See table on page 65 .
Advanced New data format with more

information and many new

values.

See table on page 66 .
Server IP Set up an IP-address to be used for collecting

log data for each measurement via LAN.

This requires for setting up of a Server Port

number as well.
%BUBMPHTFUVQ %BUBMPHTFUVQ
-PHJOUFSWBM
-PHBMMBMBSNT
-PHHJOHFOBCMFE
-PHHJOHNPEF
-PHMBTUWBMVFT
/FUXPSLMPHHJOH
/FUXPSLMPHHJOH
/FUXPSLMPHHJOHNPEF
4FSWFS*1
4FSWFS1PSU
"DLOPXMFEHF
%JTBCMFOFUXPSLFSSPST
DZDMFT
:FT
:FT
-BTUWBMVFT
/P
:FT
$PNQBUJCMF
/P
/FUXPSLMPHHJOH/P /FUXPSLMPHHJOH:FT