Mocon AMETEK Dansensor MAP Check 3 Vacuum, User Manual

Page: 50 / 92

48 User Guide EN Dansensor
®
MAP Check 3 Vacuum
P/N 320598-G
11/2019
Test modes in Diagnostics
Test measuring - Cal inlet
This test is used for calibration of the sensors in the system. It is normally used for servicing
purposes.

Remove the blind plug from the input labelled “CAL. GAS IN” and connect a suitable M5
fitting.

Connect a calibration gas to the input.

The gas must be regulated using a needle valve for a flow of 0.5 L/min ± 0.1 L/min.

Apply vacuum to the device and stop the packaging machine.

Enter Diagnostics and go to page 2 and select Test measuring - Cal inlet in the menu.

The device starts a continuous measurement of the connected calibration gas.

It is now possible to close the Diagnostics window and to go to the measuring screen to
watch the gas values.

The measuring screen will say “Test measuring”.


The test will run until you press Stop or until Test measuring - Cal inlet is pressed again on
page 2 in Diagnostics .
NOTE! Always install the blind plug in the “CAL. GAS IN” input when not in use.
25: Meat Mix 1000gr.
Cycles
6250
Test measuring
O
2
Bal
CO
2
%
%
%
Buffer
09:42
%O
2
%CO
2
bar
21,0
0,0
2,2