Mobeye MS100BK, Installation Manual

Page: 6 / 23

4
2. TO GET READY IN SEVEN STEPS
To get started with the Mobeye MS100BK seven easy steps are needed.
1. Place the SIM card
2. Connect a sensor to the input
3. Insert the four batteries
4. Connect the power supply
5. Enter at least one phone number
6. Check the settings
7. Switching on
2.1 PLACE THE SIM CARD
To use the Mobeye MS100BK a SIM card from any network is needed. On this SIM card, the
PIN code security needs to be disabled or 0000. If you have a SIM card with PIN code, you
can disable or change this using any mobile phone and change the PIN
code security. Please consult the manual for that mobile phone for the
procedure.
The SIM card needs to be inserted before the batteries. When using a
prepaid SIM card, take note of the available credit. Additionally it is wise
to set a recurrent test message in the menu so the card will be used at
least once a month.
•
Open the back cover
•
Insert the SIM card in the holder. For opening/closing, move the cover
slightly.
2.2 CONNECT A SENSOR
Open the hole in the enclosure and insert the 2 wires of an external
sensor through the hole of the enclosure to the inside part and next in
the two connectors of input 1 (press the orange pins for connecting the
wires). It does not matter which wire is connected to which connector. If
necessary the wires can be extended using appropriate wire material.
If the sensor should be closed in normal situation (and be opened in the
event of an alarm), the input type should be changed (please refer to
paragraph 6.11).
2.3 INSERT THE BATTERIES
Insert the four lithium 3,0 volt batteries (CR123). When replacing the batteries, all settings
remain unchanged.
After inserting the SIM card and the batteries, the Mobeye MS100BK will perform a self test
taking 1 minute. During the test, the light is red.
If the light is flashing red, a problem with the SIM card is detected. A reason could be no SIM
card was placed, or the PIN code security of the SIM card was not disabled.
IN1