Mobeye MS100BK, Installation Manual

Page: 14 / 23

12
6.15 AUTHORISATIONS AND REMOTE CONTROL
When powered externally, the GSM module is
always ‘on’, able to receive SMS commands.
This enables both programming and remote control. Remote control actions are: arming,
disarming and switching the outputs. As prerequisite for remote control the ‘controlling
telephone number’ needs to be authorised. A maximum of fifty numbers can be authorised
via keypad or SMS command. If it is not clear what memory positions are available, it is
possible to add a new number by the SMS command ‘ADDTELA’ . The new number takes
the first free position.
To receive a list with the authorised numbers, please refer to 9.3.
SMS-commands for remote control (no code is necessary, numbers need to be authorised):
Arm:
ARM
Disarm: DISARM
Switch on output 1: O1ON
Switch off output 1: O1OFF
Switch on output 2: O2ON
Switch off output 2: O2OFF
6.16 UNAUTHORISED SWITCHING OF OUTPUTS
Although the Mobeye MS100BK is designed to only switch the outputs by an incoming SMS
(or call, see chapter 7) from an authorized phone, there is also an option to let them be
switched by any incoming call/SMS, without being authorised. To disable the need for
authorised numbers, the 'authorization' option can be set to OFF. Default is ON.
6.17 DURATION OF OUTPUTS: SWITCH OR PULSE TIMES
If an output is used, the time this output is activated can be set between 1 and 9999
seconds. If the setting is set to 0, the output does not return to its previous state
automatically. An authorised number can switch it back by the SMS command O1OFF or
O2OFF. In the factory settings the duration of the pulse time for the outputs
is “10”.
6.18 INITIAL STATE OUTPUT
In the factory settings the outputs are set to
“open” (NO); thye close after e.g. the SMS
command "O1ON". This initial state can be set to
“closed” (NC).
6.19 RESET TO FACTORY SETTINGS
It is possible to reset the Mobeye MS100BK to factory settings.
Via the keypad
•
Enter your 4 digit installation
code (factory setting: “1111”)
•
Press “menu”
•
Enter “99”
•
Press “OK”
Via the reset button
•
Remove power adapter and /or batteries
•
Restore the power source and keep the reset button pressed for about
15 seconds until a short melody sounds followed by 3 beeps.
•
Release the button when the LED flashes
After several seconds a short confirmation tone is heard. The installation
code is also reset to 1111.