©
2000-2006 Router Technologies
All Rights Reserved
Note: Cross lines for locating and drilling holes are accurate. The illustration of subbase may vary
slightly in size and design, but is accurate enough for cutting the rubber gasket if required.
Page 9
Refer to pages 4-5-6 before using template
Additional Templates Available on Website
Drill .500" hole
through router
table insert plate
Router Raizer Access Point
NOTE: This hole must be drilled 1/2" or .500"
for #30 dust cover insert to fit properly.
Router table fence reference line
Sub-base mounting holes
Use this 6" scale to check accuracy when copied
MLCS Marvel 60
Router Raizer Access Point
5/16" reference circle for drilling
subbase.
.500" reference circle
for drilling table top or
insert plate.
1/2" = .500
install #30 dust cover insert
into .500" hole and press flush
with top of insert plate